Manufacturing and Fabrication Certificate of Accomplishment - Active
Department: Engineering & Technology
Approval: February 2016
Effective Semester: Fall 2016
This certificate program is designed to provide the student with instruction in basic welding, machining, and fabrication processes. Students completing this certificate program will be qualified for manufacturing apprenticeships or internships.
Learning Outcomes
Upon completion of this program, students will be able to:

Students must complete each course with a grade of "C" or higher.

The minimum time for completion of this certificate is 2 semesters. Completion time will vary based on student preparation and number of units completed per semester.

Courses Required for the Certificate of Accomplishment in Manufacturing and Fabrication
Course Units
Required courses:
WELD 140 - Manufacturing Processes 3.00
WELD 144A - Survey of Welding Processes 2.00
WELD 144B - Intermediate Welding Processes 2.00
Total: 7.00
Elective Courses: Choose 3 units from the following
CAD 190 - Part Modeling in SolidWorks 2.50
ELEC 101 - Electronics I: Essentials of Electronics - Measurements and Passive Circuits 2.50
WELD 144C - Advanced Welding Processes 2.00
ENGN 48L - Introduction to Engineering and Technology - Laboratory 1.00
ET 104 - Introduction to Engineering Drawing and Manufacturing 2.00
ENGN 48L & ET 104 must both be taken for the 3 units to apply towards the certificate
Total: 3.00
Total: 10.00